Products

AquaMatic K53 diaphragm valves are a customizable valve solution with glass-filled thermoplastic body and cap intended for corrosive applications for any water treatment application.

Features & Benefits

• Unique Y-pattern design with large seat opening and high lift disc permits higher flow rates at lower pressure loss than other comparable valves
• All components can be serviced while the valve is in-line
• Separate flow and control chambers permit positive closing without springs; and only nominal cost for spring assist opening for low-pressure and self- draining applications
• Pre-formed, stress-relieved diaphragm minimizes fatigue, maximizes valve responsiveness and diaphragm lifetime
• Diaphragm acts as an actuator, eliminating the need for electric or pneumatic actuators
• All internal parts in contact with media are made of composite materials*
• Seals are ethylene propylene for better chemical resistance**
• Two dynamic O-rings on the shaft, with a vent in between the O-rings, to prevent damage to the diaphragm
• Female socket weld connectors for easy installation and the ability to remove the valve without disrupting the service piping
• Valve bodies provided with molded pads that can be used to support the piping manifold
• Cap held by a retaining ring, eliminating screws and nuts; no external metal parts to corrode in aggressive environment
• Available in sizes from 1″-3″
• A variety of end connectors are available to make the valve compatible in pipe sizes from 3/4″-3″
• Adaptable to a wide variety of control devices

Options

• Normally open [standard]
• Externally normally closed
• Spring-assist closed Spring-assist open
• Fully adjustable Limit Stop from full-open to full-closed, with a Position Indicator to show the valve position
• Seal and diaphragm materials for special applications